The title says it all - how do I remove that little "half-moon" type clip from the foot peg? It almost looks like a washer with a section removed, like the letter "C". I would like to try out my Knight Design lowered foot peg.
There is a lynch pin/cotter pin (I don't know the proper term) that secures the nut holding everything on the rear axle together. It would appear that in order to install the rear (T-Rex brand) axle slider, this pin must be removed. Why does this not seem like a good idea to me? Any suggestions?
* Last updated by: kixxit on 7/3/2015 @ 9:05 PM *