A couple months ago I purchased a 2012 ZX14r and it came with a few extras. I also have an 06' ZX14. I have pretty much equipped them the same and I have a few items I do not need. Maybe another member is interested.

1st item: Strada 7 Racing Handle Bar Ends. I believe to be S7R-HBE bar ends that have never been installed, although the package has been opened. They are complete with bolts/nuts, wrench and two different size rubber inserts. Here is the link to the reference I found: Strada 7 Racing

How about $10 bucks plus shipping from 85937

2nd item: SpeedMetal Swing Arm Spools. These are metal and labeled 'SPEEDMETAL', and I think they are as sold from Cycle Gear. Here is the reference link I used:
Cycle Gear SpeedMetal Spools
It appears these were installed and lightly used, so there are some scratches (see photos).

How about $10 bucks plus shipping from 85937

Also I have a set of shorty levers (black) that I'm sure are China knock-offs. If anyone is interested send me a PM or reply here and I can get some photos.

* Last updated by: EagleSix on 2/4/2018 @ 1:50 PM *

NICE..glwts Eagle;)

Nice bar ends. I would like to go with something shorter like that but I don't think those will fit the 14. If memory serves, there is a rounded plastic nob at the tip of the handlebar that the bar end tightens against. You might be able to make it work if you dremmel out a recess on the back of the bar end so it fits around that nob like the OEM bar ends. If they were blue or silver, I'd give it a whirl. Nice.

* Last updated by: Rook on 2/4/2018 @ 7:13 PM *

I'm going riding later today and will pull off a bar end to compare to these and post back if they will fit.

Rook: Nice bar ends. I would like to go with something shorter like that but I don't think those will fit the 14

Thank You for the heads up Rook. I pulled a bar end off my 2012-ZX14R and you are correct, these will not fit. As I only have 2 ZX14's I have nothing else to compare them to. But if anyone wants them, pay the shipping and they are yours.

I pulled a bar end off my 2012-ZX14R and you are correct, these will not fit. ...if anyone wants them, pay the shipping and they are yours.

For the cost of shipping, that is a bargain. I think you could just drill the backs out with a 7/8" drill bit and they would fit. I see that bit for $12 from walmart.

Too bad these aren't gold because that is probably what I am going to do someday when I order a set.