Need some help with my PCV setup. Trying to get the speed calibration set so I can get my gears programmed. Want my autotune to tune for each gear. Have downloaded the latest firmware update and still no luck. DynoJet tech was absolutely no help what so ever. Any ideas, solutions will be appreciated thanks ahead of time.

What have you tried so far?

Speed sensor is wired to PCV? (Third connector counting from outer edge)

Everything is installed as Dynojet specifies, went over all that with the DJ tech. Going to call them again tomorrow maybe I just had a bad tech off work tomorrow so I'll have more time to mess with it.

Figured it out bad wire to vehicle speed sensor

glad you figured it out.

last time i had troubles with dj products, they were very...very patient to help me to figure out that i had ordered totally wrong parts