Page: 1 2
Created on: 02/10/12 08:39 PM
Replies: 38
wfozx14
Location:
Joined: 12/16/12
Posts: 891
RE: ZX14 matching hard bags
02/07/15 8:19 PM
yannih
Location:
Joined: 11/08/12
Posts: 2167
RE: ZX14 matching hard bags
02/07/15 8:45 PM
You boys be careful riding and lane splitting with those huge things attached to the sides of your bikes.
We dont want any incidents like the link attached...
* Last updated by: yannih on 2/9/2015 @ 12:35 AM *
lawlist
Location:
Joined: 05/24/12
Posts: 28
yannih
Location:
Joined: 11/08/12
Posts: 2167
RE: ZX14 matching hard bags
02/07/15 8:58 PM
True, but my point is as long as you remember they are there!
Old matey in the video didn't and I'm assuming that didn't tickle...
* Last updated by: yannih on 4/11/2015 @ 12:21 AM *
mrwoo
Location: Lincoln, CA
Joined: 04/17/14
Posts: 381
Danno
Location:
Joined: 12/18/11
Posts: 2142
RE: ZX14 matching hard bags
02/14/15 5:03 AM
Relocate to where there are no traffic jams.
* Last updated by: Danno on 2/14/2015 @ 5:20 AM *
KurtG68o
Location:
Joined: 02/07/15
Posts: 4
RE: ZX14 matching hard bags
02/14/15 11:47 AM
Danno ~ I like you set up on your bike.
I just ordered a Zero G sport touring windscreen, I was about to order a Laminar Lip to add to it. Have you checked out the differences between that and your "ZGST windscreen with MRA X-screen adjustable spoiler". I think I like the look of the MRA X-screen. Does it work well?
NeedForSpeed
Location: PNW
Joined: 08/29/13
Posts: 217
mjpzx14
Location: columbus, ohio
Joined: 09/09/14
Posts: 5
RE: ZX14 matching hard bags
03/03/15 2:15 PM
Hi Kurt,
welcome. They stop at 2011 because the exhaust on 2012 and up is bigger and the bags don't fit. The mount and all is the same so you either have to replace your exhaust with something smaller or I have seen some people make an extension bracket that lowers the exhaust an inch. Once you get the exhaust out of the way everything should mount up.
doubleD
Joined: 06/16/14
Posts: 390
Danno
Location:
Joined: 12/18/11
Posts: 2142
RE: ZX14 matching hard bags
04/11/15 10:55 AM
I just ordered a Zero G sport touring windscreen, I was about to order a Laminar Lip to add to it. Have you checked out the differences between that and your "ZGST windscreen with MRA X-screen adjustable spoiler". I think I like the look of the MRA X-screen. Does it work well?-KurtG68o
I've used Laminar Lips before. The X-creen is a little more versatile due to the adjustability. You can tune the windblast to your liking somewhat whereas the Lip has a static effect that you'll either like or not.
KJ6TQG
Joined: 03/11/15
Posts: 19
RE: ZX14 matching hard bags
04/12/15 1:07 AM
Everybody did such clean work converting their ZX14 to a bagger. A really good job by all. That Youtube of the guy going over the side was really an unfortunate incident, I hope he did not get too hurt out of that fopah. The bike is wasted for sure. I like my ZX14R just the way it is, but that is is just me. The Concourse is set up really nice. If I was going to do the bagger thing, I would just get a Concourse and call it a day
* Last updated by: KJ6TQG on 4/12/2015 @ 1:09 AM *
Danno
Location:
Joined: 12/18/11
Posts: 2142
RE: ZX14 matching hard bags
04/12/15 3:16 AM
Here's my "bagger" headed to Monument Valley
The Givis and 95% of their mounting hardware come off in two shakes, leaving a clean look, so you don't have to ride around with them all the time if you don't need them. Although the Concours' bags pop off also, I'm not interested in shaft drive and an extra 100 lbs of weight. The extra wind protection would be nice, though.
doubleD
Joined: 06/16/14
Posts: 390
RE: ZX14 matching hard bags
04/12/15 9:22 PM
The Concours is heavy. It has the old engine. I really like my Ignition Key. I like the lower seat on the Ninja. The Ninja is so balanced even with a full tank of fuel.
I don't need a huge fairing to ride behind. Damn that C14 would take up too much room in the garage!
I weighed my load (94 lb.)and my Bike (560 lb.)= 654 lb. The C14 weighs more not loaded.
Kawasaki should trim the fat off the C14 and put in the 1000 supercharged motor!
Page: 1 2
New Post
Please login to post a response.